BRC pressure sensor MAP Turbo

Safety instructions for BRC pressure sensor MAP Turbo:

Safety instructions for installation: - Ensure that the device is properly installed and that all connections are tight. - Follow the manufacturer's specific instructions for mounting the pressure sensor. - Use only approved mounting materials and methods. - Ensure that the device is properly earthed before commissioning.

Safety instructions for commissioning: - Before commissioning, check that all connections and cables are properly connected. - Observe the recommended operating parameters and ensure that they are adhered to. - Check that the device is properly calibrated and adjusted. - Follow all the manufacturer's specific instructions for commissioning the pressure sensor.

Safety instructions for maintenance and cleaning: - Switch off the device before maintenance or cleaning and disconnect it from the power supply. - Only use cleaning and maintenance agents recommended by the manufacturer. - Follow the manufacturer's specific instructions for maintaining and cleaning the pressure sensor. - Do not carry out any internal repairs or modifications to the device unless you are authorised to do so by the manufacturer.

General safety instructions: - Read all operating instructions and safety instructions carefully before using the pressure sensor. - Observe all applicable national and international regulations and standards. - Avoid contact with sharp edges or aggressive chemicals to prevent damage to the device. - Keep the appliance out of the reach of children and unauthorised persons. Please note that these safety instructions are of a general nature and that the manufacturer's specific instructions must always be observed.