- Product description
Gas regulator system for direct mounting on the RV propane tank - "Gas utilisation while driving"
The set consists of a 30mbar 1.5 kg/h gas regulator system, control and switch panel andthe crashprotection unit (CPU).
The regulator system can beinstalled on both 30° and 105° fuel tanks. The crash sensor is installed separately inside the vehicle.
Thanks to the patented Crash Protection Unit (CPU), it is possible to use appliances such as heaters, refrigerators, etc. both when the vehicle is stationary and whentravelling. The CPU is firmly connected to the chassis at any point inside the vehicle using 4 screws.
In the event of an accident, emergency braking or an inclineof 57° or more,the gas supply isinterrupted immediately. In addition, almost all common gas warning devices can be connected directly to the CPU. In the event of a "gas alarm", the gas supply is also interrupted immediately to maximise your safety.
The Crah sensor integrated in the CPU can be reset via the switch in the vehicle cockpit.
The EU heater directives in accordance with 2001/56/EC, including the special regulations for France, are fully complied with. Two high-pressure hoses with hose rupture safety devices (SBS) can be connected.
Technical data:
Outlet pressure: 30 mbar
Flow rate: 1.5 kg/h
Combination LPG tank/gas cylinder connection:
- 21.8 union nut left-hand thread
- G. 5 Large cylinder connection (5, 11 kg gas cylinders)
- G. 12 Small cylinder connection (33 kg gas cylinders)
- Direct connection to the RV propane tank (21.8 mm)
Regulator outlet: 10 mm pipework with adapter piece to 8 mm pipework
Scope of delivery:
- Regulator system 30 mbar / 1.5 kg/h with test valve
- Connection for 8 mm and 10 mm gas pipe
- Control unit with crash sensor
- Display and control element (on/off switch)
- 3 m connection cable from solenoid valve to control unit
- 8 m control cable (control unit to control panel)
- Installation and operating instructions
Safety instructions and warnings
Safety instructions for Cavagna gas regulator, regulator system 30 mbar 1.5 kg/h with crash sensor
1. read the manufacturer's instructions carefully before using the product.
2 Ensure that the gas regulator is only installed and maintained by authorised specialist personnel.
3. regularly check the condition of the gas regulator and check for damage or wear.
4. use the product only for its intended purpose and within the specified operating parameters.
5. install the gas regulator in accordance with the manufacturer's instructions and observe all local regulations and standards.
6 Ensure that the gas cylinder is properly secured and has no leaks.
7. avoid using the gas regulator near flammable materials or open flames.
8. protect the gas regulator from extreme temperatures, moisture and aggressive chemicals.
9. if problems or irregularities occur, contact the manufacturer or an authorised specialist immediately.
10. keep the product out of the reach of children and pets.
11. observe all applicable safety rules and regulations for handling gas regulators.
Important note: These safety instructions serve as general guidelines. Always consult the manufacturer's documentation and follow the manufacturer's specific instructions for the safe operation of the Cavagna gas regulator, regulator system 30 mbar 1.5kg/h with crash sensor.
Manufacturer contact information
Contact manufacturer
Cavagna Group
Via Statale n. 11/13
25011 Ponte S. Marco di Calcinato
Brescia - Italy
https://www.cavagnagroup.com/contacts/