- Product description
- Spare parts
- Accessories
Homologation number E8 67R-01 4303
Technical data IG1 Rail | |
| Working pressure | from 0.5 to 2.0 bar |
| Maximum pressure | 3.0 bar |
| Operating voltage | 10,8-14,4 V |
| Inlet connection | ø12 mm |
| Connections at the outlet | Pre-drilled nozzles M8x1 |
| Temperature range | -20° / + 120° C |
| Resistance | 2.0 Ohm |
| Minimum injection time | 3.3 ms |
| Open | 3.7 ms* |
| Close | 2.8 ms* |
* tested at 1 bar pressure 12V and 5ms total injection time
Safety instructions and warnings
Safety instructions for RAIL injector LPG CNG IG1 3 cylinder BLACK BODY 2 Ohm (old version)
1. before installing or servicing the product, make sure that the power supply is switched off
2. use only spare parts recommended by the manufacturer to ensure the proper functioning of the injector.
3. do not touch the injector while it is in operation or while it is still hot.
4 Ensure that the injector is properly grounded to avoid potential electrical hazards.
5. use the product only in accordance with the manufacturer's instructions and do not exceed the specified limits.
6. ensure that the injector is installed in a well-ventilated location to avoid the accumulation of gases.
7. regularly check the condition of the injector and, if necessary, carry out maintenance work in accordance with the manufacturer's guidelines.
8. if you have any doubts or questions about the installation or operation of the injector, contact a qualified specialist or the manufacturer.
9. keep the product out of the reach of children and pets.
10. observe all applicable safety rules and regulations when using the product.
Manufacturer Contact Information
Rail S.r.l.
Via A. Grandi, 16
42030 Vezzano Sul Crostolo (RE)
Italy
+39 0522 603 801
info@railgroup.it
