- Product description
Flexible gas pipe - 6mm - 6m KIT thermoplastic hose with FASTYFIT connections
KIT contains:
- 2 x 6mm union nut
- 2 x 6mm cutting ring
- 2 x 6mm spigots for FASTYFIT connection
- 2 x 6mm quick connector FASTYFIT
- 6m x 6mm FARO PREMIUM thermoplastic cable
ATTENTION: the pipe can only be used with original and homologated FARO fittings.
Maximum working pressure: 30 bar
Working temperature: -25°C +125°C
Area of application: LPG
Homologation: ECE R67-01
Roll length: 6m
After two years of development, FARO presents the FastyFit system for the LPG automotive market. It is a quick connection system that will revolutionise the current way of installing lines.
FastyFit is a patented and ECE R67.01 homologated system that has been developed from a deep understanding of the problems and requirements that arise when installing LPG systems.
- increased safety
- easier installation
- time and cost savings
The FastyFit product line isdesignedexclusively for FAROPREMIUM flexible pipesand cannot be used for metal pipes. The product line consists of:
-FastyFitquick: six straight and 90° fittings for 6 and 8mm pipes, 100% tested and equipped with a special O-ring to withstand the high temperature fluctuations and aggressive substances when operating with LPG.
-FastyFitnipple: two pipe sockets with plug-in connection profile for 6 and 8 mm pipes
-FastyFitkey: special spanner to release the quick-fit connections of 6 and 8 mm pipes
-FastyFitlubricant: Lubricant to reduce friction and wear. The chemical formula required many months of development and laboratory testing and was developed using parameters such as the Stribeck curve.
Safety instructions and warnings
Safety instructions for FARO PREMIUM thermoplastic hose 6 mm (3/16") - 6 metre FASTYFIT KIT
1. before you start installing or using the thermoplastic hose, please read the manufacturer's instructions thoroughly.
2. ensure that the thermoplastic hose is suitable for the intended use.
3. regularly check the thermoplastic hose for damage such as cracks, cuts or signs of wear. Do not use the thermoplastic hose if such damage is found.
4. avoid excessive bending or kinking of the thermoplastic hose, as this can lead to damage.
5. ensure that the thermoplastic hose does not come into contact with sharp objects that could damage the surface.
6. do not use the thermoplastic hose in environments with high temperatures or near open flames.
7. ensure that the thermoplastic hose is not overloaded. Ensure that it is designed for the maximum load.
8. keep the thermoplastic hose away from chemical substances, oils and solvents, as these could damage the thermoplastic hose.
9. make sure that the thermoplastic hose is properly connected and fastened to prevent accidental disconnection.
10. switch off the corresponding device before connecting or removing the thermoplastic hose.
11. if you have any doubts or questions about the use of the thermoplastic hose, contact the manufacturer or a qualified specialist.
Manufacturer contact information
Manufacturer Contact
OMB Saleri S.P.A.
Via Rose di Sotto 38
25126 Brescia BS
Italy
info@faro-brescia.it