Injector nozzle for Valtek rail G 1/8’’ D. 6 mm (2,75 mm)

Safety instructions for injector nozzle G 1/8''D.6mm - for Valtek T30 injector (2.75mm Bore hole)

1. read the manufacturer's instructions thoroughly before using the injector nozzle G 1/8''D.6mm - for Valtek T30 injector (2.75mm bore hole).

2. make sure that the injector nozzle is properly installed and that the connecting parts are tightened.

3. use suitable protective equipment such as gloves, safety goggles and hearing protection when handling the injector nozzle.

4. regularly check the condition of the injector nozzle and replace it if there are signs of wear or damage.

5 Keep children and unauthorised persons away from the injector nozzle.

6. avoid direct contact with the outlet openings of the injector nozzle to prevent injuries.

7. observe the recommended operating parameters and ensure that the Valtek T30 injector (2.75mm Bore hole) is properly adjusted.

8. keep the injector nozzle and injector clean to ensure optimal performance.

9. observe all applicable safety standards and regulations when using the injector nozzle.

10. if you have any questions or uncertainties, contact the manufacturer or an authorised specialist dealer.