DREHMEISTER reducer for 8 mm FARO thermoplastic hose to 4-hole tanks 1/2-20 UNF (N06)

Safety instructions for DREHMEISTER reducer for FARO thermoplastic hose 8mm to 4-hole tank 1/2-20 UNF (N06)

1. general safety instructions:

- Please read these instructions carefully before you start using the product. - Keep the reducer out of the reach of children. - Regularly check the condition of the reducer for damage or signs of wear and do not use it if it is defective. - Only use the reducer for its intended purpose and in accordance with the manufacturer's instructions.

2. safety instructions for installation:

- Make sure that the thermoplastic hose and the 4-hole tank are compatible and that the reducer fits properly. - Make sure the thermoplastic hose and 4-hole tank are clean and free of dirt or debris before installing the reducer. - Tighten the connecting screws to ensure a secure and reliable connection between the thermoplastic hose and the 4-hole tank.

3. operating instructions:

- Regularly check the condition of the reducer and the entire connection to ensure that it is tight and secure. - Do not use the reducer if it is damaged or worn. In this case, replace it immediately. - Follow the manufacturer's specific instructions for use and maintenance of the reducer. - Do not use the reducer above the specified temperature and pressure ranges.

4 Disposal instructions:

- Dispose of the reducer in accordance with local regulations and guidelines for electrical and electronic equipment.

5. disclaimer:

- The manufacturer accepts no liability for damage or injury caused by improper use or installation of the reducer.

Important notice:

These safety and operating instructions serve as general guidelines. Please consult the manufacturer's instructions or contact the manufacturer for detailed and up-to-date information.