- Product description
- Accessories
DREHMEISTER compression fitting for polyamide hose on the intake manifold
With the DREHMEISTER compression fitting, polyamide hose can be firmly fixed from one side thanks to the union nut and clamping ring, while the other side (M10x1 thread) is attached to the intake manifold. The polymide hose can thus be inserted into the intake manifold in a controlled manner without being sucked in itself.
This method is used when converting vehicles to LPG in order to bring the injection point of the LPG fuel closer to the intake valves. The temperature-resistant polyamide hose serves as an extended manifold nozzle in the intake manifold. The outward-facing end of the polyamide hose is connected to a 5 mm or 6 mm gas hose and a clamp and leads to the LPG injector.
Safety instructions and warnings
Safety instructions for DREHMEISTER bushing M10x1 for polyamide hose 6mm:
- Always switch off the power supply before installing or servicing the product.
- Ensure that the polyamide hose is correctly dimensioned and meets the requirements.
- Only use the assembly and connection elements recommended by the manufacturer.
- Regularly check the condition of the polyamide hose for damage or wear.
- Ensure that the polyamide hose is not excessively bent, stretched or kinked.
- Avoid contact of the polyamide hose with sharp edges or aggressive chemicals.
- Ensure that all connections and screw fittings are properly tightened.
- Observe the specified maximum operating pressures and temperatures for the polyamide hose.
- Keep the product out of the reach of children and unauthorised persons.
- If you have any questions or uncertainties, always contact the manufacturer or authorised specialist personnel.
