- Product description
220W PERC solar module for motorhomes, complete solar module camping for motorhomes, campers, caravans.
The PERC technology (Passivated Emitter and Rear Cell), patented for almost 30 years, enables improved light capture and optimizes energy production, even in overcast conditions.
The efficiency of these cells makes it possible to obtain up to 20% more energy compared to a standard monocrystalline module.
- Series of solar modules with PERC solar cells.
- Corrugated anodized aluminium mounting brackets to improve the adhesion of the module when glued to the roof.
- Waterproof junction box for a high level of safety.
- High-performance bypass diodes to minimize power loss in low solar irradiation.
- Protection made of specially tempered glass that can withstand weather conditions.
- Series or parallel connection possible and unlimited
Installation instructions
- Draw a new power supply directly from the battery for each solar module.
- Do not use existing circuits or go through existing devices and/or terminal blocks.
- Do not use existing circuit breakers.
- Each drawn feed must have a suitable fuse on the "+" line. This fuse must be placed as close as possible to the battery.
- Every product with electronic elements must be protected against undervoltage (below 11 volts) and overvoltage (above 15 volts).
Bonding the solar module
We recommend the use of Dekalin MS1 adhesive in accordance with the preparation instructions.
- Temperature condition for the use of the adhesive: between 10 and 25°C.
- Sand the surfaces to be bonded with sandpaper (medium grit).
- Clean the surface with a product recommended by the adhesive manufacturer (Dekaclean from Dekalin)
- In the case of a flexible solar panel: Glue the entire outer perimeter of the panel with a net of adhesive
lot (width1 cm ) without interruption. Under no circumstances should you place individual large dots of adhesive.
This could damage the cells of the panel (the warranty for the panel is void and cannot be claimed).
- For a rigid solar panel: Glue the mounting tabs generously to both ends of the panel.
At the ends of the panel. A thickness of +/- 3 mm should remain.
- Apply medium pressure to the solar panel. A thickness of +/- 3 mm should remain.
- Drying time: 24 hours
Technical data
Output 220 watts
Nominal voltage (volts) 23.56
Rated current (amperes) 9.34
Maximum voltage (volts) 27.36
Maximum voltage (amperes) 9.0
Daily production (amps)* 57
Dimensions 1565x680x45 mm
Weight 12.7 kg
Manufacturer's warranty 10 years