LOCTITE® 573 green - slow curing, seals close-fitting joints between rigid metal faces and flanges
LOCTITE® 573 green - slow curing, seals close-fitting joints between rigid metal faces and flanges

LOCTITE® 573 green - slow curing, seals close-fitting joints between rigid metal faces and flanges

Article no.: 124261
Manufacturer: Loctite

Offer is exclusively for commercial customers. Prices are only visible after login.

  • Product description

Features and benefits:

Loctite 573 is a surface sealant that can be used primarily where a long curing and assembly time must be accepted. Especially for parts that are more difficult to assemble. After curing without air access in the joint between bonded metal surfaces, Loctite 573 achieves medium strength and prevents the escape of liquids and gases.

Thanks to this seal, there is no direct contact between the metal surfaces of the flange, so that no contact corrosion occurs. The thixotropic character is advantageous, preventing run-off from the point of application. It is recommended to use Loctite 573 as a locally produced sealant especially for rigid flange connections, typically gearboxes, motor housings etc.

Safety instructions and warnings

Safety Instructions for LOCTITE® 573 green - slow curing, seals tightly fitting joints between rigid metal surfaces and flanges:

  • Keep the product out of the reach of children.
  • Read and understand all safety and operating instructions before use.
  • The product should be stored at room temperature (between 8°C and 28°C).
  • Suitable gloves, protective clothing and goggles should be worn when handling the product.
  • Do not inhale or ingest the product.
  • In case of contact with skin, wash immediately with plenty of soap and water and seek medical advice.
  • In case of eye contact, rinse immediately with plenty of water and seek medical advice.
  • The product must not be released into the environment. Dispose of in accordance with local regulations.
  • When using the product, the applicable laws and regulations should be observed.

Operating Instructions for LOCTITE® 573 green - slow curing, seals close fitting joints between rigid metal surfaces and flanges:

  • The surfaces to be bonded must be clean, dry and free of grease.
  • The product should be applied in thin layers in order to achieve an optimum effect.
  • The curing time may vary depending on the ambient temperature and humidity.
  • Maximum strength is achieved after 24 hours.
  • The recommended application temperatures are between -55°C and 150°C.
Manufacturer contact information

Contact Manufacturer

Henkel AG & Co KGaA
Henkelstrasse 67
40589 Düsseldorf

https://www.henkel-adhesives.com/de/de/%C3%BCber-uns/kontakt.html

Subscribe to our newsletter
Our newsletter is free of charge and can be canceled at any time here or in your customer account.