- Product description
If you operate high wattage consumers on the inverter, it is advisable to additionally protect the on-board battery with a high-load fuse. If a short circuit should occur due to brief current peaks, in the worst case the fuse would blow and the damage would be limited in most cases. The fuse holder is equipped with an M8 thread on both sides. Connection screws and rubber grommets are included in the scope of delivery.
Safety instructions and warnings
Safety instructions for Dometic Büttner MT 06250 High-load fuse set for MT 1700SI/MT 1700SI-N
1 Please read the operating instructions carefully before installing and using the high-load fuse set.
2 Ensure that the product is only installed and maintained by qualified personnel.
3. ensure that the appliance is switched off and disconnected from the power supply before installing the high-load fuse set.
4. before installation, check that all components of the fuse set are complete and undamaged. If in doubt, please contact the manufacturer.
5 Only use original parts and accessories from the manufacturer for installation and maintenance.
6. ensure that all connections are correctly and securely attached to avoid possible hazards due to loose connections.
7. do not touch any electrical parts of the product while it is in operation or powered.
8. keep the high-load fuse set and all other electrical components away from water, moisture and other liquids.
9. switch off the appliance and disconnect the mains plug before carrying out maintenance work.
10. observe all applicable regulations and safety requirements during installation, use and maintenance of the high-load fuse set.
Manufacturer contact information
Manufacturer Contact
Dometic Germany GmbH
Hollefeldstraße 63
48282 Emsdetten
Dometic Germany
https://www.dometic.com/de-de/support-und-service/formular-fur-den-produktsupport