Votronic Automatic Charger VAC 1215/15 Duo

2 completely separate and independent charging units in one device
Charging programmes no. 1, 2, 3 and 5 (gel, AGM, acid, start) adjustable to battery type for each charging unit
Battery capacity can be set 4 times for each charging section (16 charging programmes in total)
Outstanding charging technology
Signalling output (MA) +86 for engine start inhibit when connected to the vehicle power supply
Automatic battery regeneration for long downtimes (twice a week)
Compensation of voltage losses on the charging cables for exact compliance with the charging voltages
Disconnection of the batteries in the event of mains failure, overheating, incorrect behaviour (safety switch per charging output)
Electronics protected against moisture
The charging voltages are free of peaks and regulated to prevent overcharging
Fully automatic continuous operation for constant operational readiness of the batteries
Precise battery temperature compensation, temperature sensor included in the scope of delivery
Intelligent microprocessor control takes into account the simultaneous co-supply of consumers on the battery
Built-in 200A battery bridging function for emergency engine start
Emergency engine start can also be operated remotely with a simple push-button switch, e.g. from the dashboard

Optional accessories:

Charging power in [V]/[A]	12 / 15 / 15
Nominal voltage (AC) in [V]	230
Operating voltage range (AC) in [V]	190 - 265 (full charging capacity)
Power consumption (AC) in max. [W]	480
Sinusoidal power factor correction (CosPhi = 1)	yes
Nominal battery voltage (DC) in [V]	12
Battery capacity in [Ah]	36 - 170 / 36 - 170
Charging current in [A]	15 / 15
Auxiliary charging output "S" in [A]	-
Charging characteristic	IU1oU2
Voltage limitation for all charging types/programmes [V]	15
Voltage ripple in [mV] rms	< 50
Number of charging outputs	2
Device installation position	any
Temperature range [°C]	-20 to +45
Degree/class of protection	I / IP 21
Dimensions (WxHxD) in [mm] - Dimensions incl. mounting flanges, without connections	305 x 90 x 265
Weight in [g]	3700
Standards (CE)	EN 60335-2-29
Ambient conditions, humidity: max. 95% room humidity, non-condensing
Scope of delivery: Mains cable, 2 temperature sensors, operating instructions

Safety instructions and warnings

Safety instructions for Votronic Automatic Charger VAC 1215/15 Duo

Important safety instructions:

The device may only be installed and commissioned by a qualified electrician.
The device must not be operated in damp rooms or outdoors.
Before the appliance is put into operation, the battery types and the charging voltages and currents must be checked.
Do not overcharge your battery. If you suspect that your battery is being overcharged, stop the charging process immediately.
The device is equipped with a reverse polarity protection circuit. Nevertheless, make sure that the positive and negative polarity of the battery are connected correctly.
Keep the device away from children and do not leave it unattended.

Operating instructions:

The device must be set up in a dry, ventilated room without direct sunlight.
The appliance must not be overloaded. The maximum output power must not be exceeded.
The device must not be operated near water or other liquids.
Ensure that the batteries are monitored during the charging process.
The device must not be modified. Any modifications may lead to malfunctions and damage.

Manufacturer contact information

Manufacturer Contact

VOTRONIC Elektronik-Systeme GmbH
Johann-Friedrich-Diehm-Str. 2
36341 Lauterbach

https://www.votronic.de/kontakt/