- Product description
- Charging programmes no. 5, 6, 7, 8 and 9 (start, gel, AGM, acid) adjustable to battery type
- Outstanding charging technology
- Fully automatic continuous operation for constant operational readiness of the batteries
- The charging voltages are free of peaks and regulated in such a way that overcharging is ruled out
- Trouble-free operation and co-supply of the devices connected to the vehicle electrical system
- Built-in charging current distributor with 2 main charging outputs, both with maximum current and power capacity
- Charging current distributor output "2" can optionally be switched to a separate charging programme for the starter battery
- Starter battery is also charged with full charging current if required (short vehicle service life)
- Signal output (MA) +86 for engine start inhibit with vehicle mains connection
- Visual and acoustic warning in the event of battery and operating errors
- Precise battery temperature compensation, temperature sensor included in scope of delivery
- Automatic battery regeneration during long downtimes (twice a week)
- Compensation of voltage losses on the charging cables for exact compliance with the charging voltages
- Disconnection of the batteries in the event of mains failure, overheating, incorrect behaviour (safety switch per charging output)
- Power supply function enables consumers to continue operation and data retention, e.g. when changing batteries
- Manual charging start when battery is deeply discharged in accordance with DIN 14679
- Variable installation position
- Electronics protected against moisture
- Intelligent microprocessor control takes into account the simultaneous co-supply of consumers on the battery
Optional accessories:
- Remote control S (Art. 2075)
- Remote operating display IP67 (Art. 2081)
- Charger State Monitor IP67 (Art. 2082)
Technical data
| Charging power in [V]/[A] | 24 / 16 |
| Nominal voltage (AC) in [V] | 230 |
| Operating voltage range (AC) in [V] | 190 - 265 (full charging capacity) |
| Power consumption (AC) in max. [W] | 520 |
| Sinusoidal power factor correction (CosPhi = 1) | yes |
| Nominal battery voltage (DC) in [V] | 24 |
| Battery capacity in [Ah] | 30 - 80 (160 1) |
| Charging current in [A] | 16 |
| Auxiliary charging output "S" in [A] | - |
| Charging characteristic | IU1oU2 |
| Voltage limitation for all charging types/programmes [V] | 30 |
| Voltage ripple in [mV] rms | < 50 |
| Number of charging outputs | 2 + MA |
| Device installation position | any |
| Temperature range [°C] | -20 to +45 |
| Degree/class of protection | I / IP 21 |
| Dimensions (WxHxD) in [mm] - Dimensions incl. mounting flanges, without connections | 210 x 71 x 160 |
| Weight in [g] | 1450 |
| Standards (CE) | EN 60335-2-29 |
| Ambient conditions, humidity: max. 95% room humidity, non-condensing | |
| Scope of delivery: Mains cable (2-core), 1 temperature sensor, operating instructions |
1 when vehicles are not in use for >24 hours, in accordance with DIN 14679
Safety instructions and warnings
Safety instructions for Votronic Automatic Charger VAC 2416 F 3A II
- The Votronic Automatic Charger VAC 2416 F 3A II may only be installed and commissioned by qualified personnel.
- The mains voltage must be checked for compliance with the requirements of the device before installation.
- No connection may be made between the terminals "+" and "-" of the device before the battery is connected.
- The Automatic Charger must not be operated in a damp environment or in direct sunlight.
- Sufficient ventilation of the device must be ensured to prevent overheating.
- Do not allow water to enter the device while the Automatic Charger is in operation.
- The device must never be connected to a power source that exceeds the voltage recommended by the manufacturer.
- It is prohibited to open or modify the housing of the Automatic Charger.
- The use of battery types other than those recommended by the manufacturer may result in damage to the device and battery.
- The Automatic Charger may only be used in accordance with the manufacturer's instructions.
Manufacturer contact information
Manufacturer Contact
VOTRONIC Elektronik-Systeme GmbH
Johann-Friedrich-Diehm-Str. 2
36341 Lauterbach
https://www.votronic.de/kontakt/