- Product description
Similar to diode battery isolators, FET isolators allow two or more batteries to be charged simultaneously via one dynamo (or battery charger with one output) without connecting the batteries together. In contrast to diode battery isolators, there is practically no voltage loss with FET isolators. The voltage drop is less than 0.02 volts at low current and an average of 0.1 volts at higher currents.
Technical data
Type: Battery isolators
Maximum charging current [A]: 100
Weight [kg]: 1.4
Dimensions [mm]: 200 x 120 x 65
Product guarantee: 5 years
Safety instructions and warnings
Safety instructions for Victron Energy battery isolator Argofet 100-3 100 A:
1. please read the manufacturer's instructions carefully before commissioning the product.
2. ensure that the battery isolator is installed by a qualified specialist.
3. always switch off the power supply and disconnect the battery from the system before carrying out maintenance or installation work.
4. ensure that the correct connections are used for the battery isolator and that the polarity is correct.
5. only use fuse values recommended by the manufacturer.
6. ensure that the battery isolator is properly earthed.
7. regularly check the condition of the battery and carry out maintenance work if necessary.
8. keep the product away from moisture, heat sources and direct sunlight.
9. avoid improper use or modification of the battery isolator.
10. observe the local guidelines and regulations when disposing of the product.
Manufacturer contact information
Manufacturer Contact
Victron Energy B.V.
De Paal 35
1351 JG Almere
The Netherlands
sales@victronenergy.com