170W Flexible solar panel for motorhomes, camper, rv
170W Flexible solar panel for motorhomes, camper, rv

170W Flexible solar panel for motorhomes, camper, rv

Article no.: 112763A
Manufacturer: ANTARION

Offer is exclusively for commercial customers. Prices are only visible after login.

  • Product description
  • Media & Downloads

170W flexible solar panel, camping solar panel for motorhome, camper or van. Ideal for mounting in difficult space. Solar panel supplied individually.

Ultralight solar panels specially designed for mounting in difficult space on campers, motorhomes or vans with pop-up roof.

ETFE coating for better resistance to heat.

- Solar panels are supplied individually

Waterproof junction box for high level of safety.

High power bypass diodes to minimize power drop in low sunlight conditions.

Row or parallel connection possible and unlimited

Instructions for installation

- Pull a new power supply directly from the battery for each solar panel.
- Do not use existing circuits or go through existing equipment and/or terminal blocks.
- Do not use existing circuit breakers.
- Each pulled feed must have a suitable fuse on the "+" line. This fuse must be placed as close as possible to the battery.
- Any product with electronic elements must be protected against undervoltage (below 11 volts) and overvoltage (above 15 volts).

Bonding the solar panel

We recommend using Dekalin MS1 adhesive, following the preparation instructions.

- Temperature condition for the use of the adhesive: between 10 and 25°C.
- Sand the surfaces to be bonded with sandpaper (medium grit).
- Clean the surface with a product recommended by the adhesive manufacturer (Dekaclean by Dekalin)
- In the case of a flexible solar panel: Glue the entire outer perimeter of the panel with a net of glue.
Loose (width1 cm ) without interruption. Under no circumstances should you place individual large dots of glue.
This could damage the cells of the panel (the warranty for the panel will be voided, cannot be claimed).
- For a rigid solar panel: Glue the mounting tabs generously to both ends of the panel.
At the ends of the panel. A thickness of +/- 3 mm should remain.
- Apply medium pressure to the solar panel. There should remain a thickness of +/- 3 mm.
- Drying time: 24 hours

Power 170 watts

Nominal voltage (volts) 19.8

Nominal amperage (amps) 8.59

Voltage max (volts) 23.3

Voltage max. (Amps) 9.27

Daily production (Amps)* 33.22

Dimensions 1310x680x2 mm

Weight 3.6 Kg

Manufacturer warranty 2 years