- Product description
- Media & Downloads
190W PERC solar panel for motorhome, complete solar panel camping for motorhome, camper, caravan including solar charge controller. All components of this monocrystalline PERC solar complete system are matched to each other.
The PERC technology (Passivated Emitter and Rear Cell), patented for almost 30 years, enables improved light capture and optimizes energy production, even under overcast skies.
The efficiency of these cells allows up to 20% more energy to be gained compared to a standard monocrystalline module.
- Camping solar panels come as a complete mounting kit with a MPPT solar charge controller, 5 meters of wiring, Dekalin MS-1 adhesive and Dekaclean
- Series of solar panels with PERC solar cells.
- Rippled mounting tabs made of anodized aluminum to improve the adhesion of the panel when glued to the roof.
- Waterproof junction box for a high level of security.
- High-power bypass diodes to minimize power drop in low sunlight.
- Protection made of specially tempered glass that can withstand weather conditions.
- Row or parallel connection possible and unlimited
Instructions for installation
- Pull a new power supply directly from the battery for each solar panel.
- Do not use existing circuits or go through existing equipment and/or terminal blocks.
- Do not use existing circuit breakers.
- Each pulled feed must have a suitable fuse on the "+" line. This fuse must be placed as close as possible to the battery.
- Any product with electronic elements must be protected against undervoltage (below 11 volts) and overvoltage (above 15 volts).
Bonding the solar panel
We recommend using Dekalin MS1 adhesive, following the preparation instructions.
- Temperature condition for the use of the adhesive: between 10 and 25°C.
- Sand the surfaces to be bonded with sandpaper (medium grit).
- Clean the surface with a product recommended by the adhesive manufacturer (Dekaclean by Dekalin)
- In the case of a flexible solar panel: Glue the entire outer perimeter of the panel with a net of glue.
Loose (width1 cm ) without interruption. Under no circumstances should you place individual large dots of glue.
This could damage the cells of the panel (the warranty for the panel will be voided, cannot be claimed).
- For a rigid solar panel: Glue the mounting tabs generously to both ends of the panel.
At the ends of the panel. A thickness of +/- 3 mm should remain.
- Apply medium pressure to the solar panel. There should remain a thickness of +/- 3 mm.
- Drying time: 24 hours
Power 190 watts
Technology PERC Passivated Emitter and Rear Cell
Solar Charge Controller MPPT20
Nominal voltage (volts) 19.61
Nominal amperage (amps) 9.69
Voltage max (volts) 23.3
Voltage max. (Amps) 10.68
Daily production (Amps)* 50.06
Dimensions 1655x670x60 mm
Weight 16 Kg
Manufacturer warranty 10 years
*This result was calculated based on average annual solar radiation in France during spring/summer.