Filling valve 80% for toroidal 4-hole tank 52°

Safety instructions for fill stop valve 80% for ring-shaped 4-hole tank 52°

• The fill stop valve 80% may only be used for ring-shaped 4-hole tanks with an angle of inclination of 52°.
• The valve must be properly installed and maintained to ensure proper function and safety.
• It is important that the valve is checked regularly for damage or wear. If there are signs of damage or malfunction, the valve must be replaced.
• The fill stop valve 80% must not be installed or serviced by persons without adequate training or knowledge in the handling of liquids or pressurised gases.
• The valve must not be used with flammable liquids, acids or other hazardous substances.
• The fill stop valve 80% must be completely drained before maintenance or disassembly.
• It is important that all safety and operating instructions of the manufacturer as well as all applicable laws and regulations are observed.
• The valve must not be manipulated or modified in order to change or improve its function.
• The valve must not be loaded beyond its rated capacity.
• It is important that the valve is protected from frost and moisture.