Flow regulator 19 mm for Stargas Typ E reducer

Safety instructions for flow regulators 19 mm for Stargas type E reducers

1. before installing the flow regulator, ensure that all gas lines are properly installed and tight.

2. use only approved components and accessories that are suitable for the Stargas type E reducer.

3. regularly check the condition of the flow regulator for damage or signs of wear.

4. ensure that the flow regulator is properly connected to the reducer and that there are no leaks.

5. observe the pressure and flow rate values specified by the manufacturer to ensure safe use of the flow regulator.

6. keep the flow regulator away from heat sources and open flames.

7. operate the flow regulator only in well ventilated areas to avoid the accumulation of gases.

8. before carrying out maintenance or cleaning work on the flow regulator, ensure that the gas valve is closed and that there is no gas supply.

9. if problems or irregularities occur with the flow regulator, contact the manufacturer or an authorised specialist.