KME connector for MAP sensor PS-CCT6 (DIEGO / 5 strands)

Safety instructions for KME connector for MAP sensor PS-CCT6 (DIEGO / 5-wire)

1. before installing the connector, make sure that the vehicle is properly switched off and the battery is disconnected.

2. use only original KME connectors to ensure correct function and safety.

3. read the manufacturer's instructions carefully before installation and observe all instructions and warnings.

4. ensure that the plug is correctly connected to the MAP sensor and that the connection is secure.

5. regularly check the condition of the plug and the cables in order to recognise and rectify damage or wear in good time.

6. avoid contact of the plug with water, oil or other chemical substances, as this can lead to malfunctions or short circuits.

7. keep the plug away from extreme temperatures to avoid damage.

8. if you experience any problems with the plug, contact an authorised KME dealer or the manufacturer for assistance and further instructions.

9. observe all applicable safety rules and regulations when installing and using the plug.