MTM injector harness 10-pin 4 cylinder SX

Safety instructions for MTM injector cable set 10-pin 4cyl SX:

1. before installing or servicing the cable set, make sure that the power supply is switched off and the vehicle has cooled down.

2. use only tools and materials recommended by the manufacturer to avoid damage or malfunction.

3. follow the manufacturer's specific instructions for correct wiring and installation of the wiring harness.

4. ensure that the cables are not kinked, crushed or otherwise damaged to prevent short circuits or failures.

5. keep the cable set away from heat sources, liquids and other potential hazards to ensure the safety and performance of the product.

6. regularly check the condition of the cable set and carry out any maintenance or repair work in accordance with the manufacturer's instructions.

7. observe all applicable safety regulations and standards during installation and use of the cable set.

8. if you have any questions or uncertainties, please contact the manufacturer or authorised specialist personnel.

Please note that these are only general safety instructions. Always consult the manufacturer's official documents and instructions for specific safety and operating instructions.