- Product description
Suitable for all resistors (1 Ohm / 2 Ohm / 3 Ohm).
1 repair kit corresponds to one cylinder (4 cylinders = 4 kits, 8 cylinders = 8 kits, etc.)
Note:
After repair, the injectors should be checked and adjusted using the appropriate calibration tool.
Safety instructions and warnings
Safety instructions for Valtek repair kit type 30 injector
- Installation and maintenance of the Valtek repair kit type 30 injector should only be carried out by trained personnel.
- It is important that all parts of the injector are checked for damage or wear before installation.
- Ensure that all components of the injector are installed according to the manufacturer's specifications.
- Only use spare parts approved by the manufacturer for the repair kit.
- Observe the recommended maintenance intervals and carry out regular inspections.
- Observe the hazard warnings and safety instructions in the manufacturer's manual.
- Wear suitable personal protective equipment, including eye protection and work gloves, during installation and maintenance of the injector.
- Ensure that the injector system is properly vented before it is put into operation.
- Avoid contact with hot or moving parts of the injector system during operation.
- Keep the injector system clean and free of dirt and deposits.
- Ensure that the injector system is properly earthed.
- If problems or malfunctions occur, the system should be taken out of operation immediately and checked by trained personnel.
Manufacturer contact information
VALTEK:
Westport Fuel System Italia s.r.l.
Via La Morra, 1
12062 Cherasco CN
Italy
info.valtek@wfsinc.com